aquatherm black system

Processing

 

 

  1. Home
  2.  » 
  3. Products
  4.  » 
  5. aquatherm black system
  6.  » black system Processing

Connection technology

Depending on the grid type, the individual elements are connected to each other or to the pipe either by heat fusion or by push-fit connection.

Heat fusion: The parts are connected by heat fusion (heating element socket welding) which creates a homogeneous, cohesive unit with no leak paths. Heat fusion connections are stronger than the pipe itself, providing lasting safety at these critical points of a piping system. A properly executed aquatherm fusion creates a permanent leakproof connection.

Push-fit connection: The push-fit connectors are simple and safe to use. The grids are provided with plug-in connections, on which the connector is inserted up to the stop. The holding ring is equipped with stainless steel teeth, keeping the connector firmly in the joint. The two integrated O-rings provide a sealed connection. The holding ring and the O-ring are held in place by a brass locking ring.

Instruction videos aquatherm black system

1. Ceiling system

Wooden substructure

The aquatherm black system heating/cooling grids are installed between the supporting profiles of the substructure. The ceiling is then boarded with plasterboard panels.

2. Ceiling system

Metal substructure

The aquatherm black system heating/cooling grids are installed between the supporting profiles of the substructure. The ceiling is then boarded with plasterboard panels.

3. Ceiling system

Metal ceiling panel

The aquatherm black system grids for heating and cooling are placed in the metal panels. The contact of the grids with the panels ensures excellent power transfer.

4. Ceiling system

High-performance modules

The surface temperature of aquatherm black system high-performance modules is only a few degrees above or below the desired room temperature.

5. Ceiling

Ceiling system plastered

The aquatherm black system grids and the connection piping are attached to the ceiling and then plastered. All commercially available plasters made of gypsum, lime, concrete and clay are suitable for this.

6. Wall

Use in the shower area

aquatherm black system grids provide cosy warmth in the shower area. Cold radiating tiles along with mould formation belong to the past.

7. Wall

Drywall system

When used in the wall, the aquatherm black system grids can be quickly and easily installed between the profiles or slats of the substructure. Then the wall is covered with building boards.

Contact: aquatherm GmbH | Biggen 5 |  57439 Attendorn Germany | Tel: +49 2722 950 0 |  info@aquatherm.de